GETTING STARTED WITH YOUR POLAROID SNAP TOUCH
Step 1: Charge your camera
Plug the cable into a 1amp charge block and into your camera. Make sure the camera is laid flat on the ground and the cable is not fully extended.
Step 2: Turn your camera on
Press and hold the power button until you hear the welcome sound.
Step 3: Loading paper into the printer
Always load the blue sheet facing down with the gloss of the paper up. Avoid touching the paper as much as possible by holding from the sides.
Step 4: Holding the camera for a selfie
Step 5: Holding the camera for a picture
Step 6: Take a picture
Press the shutter button to take the picture
LOAD THE PAPER
Step 1: Take the paper out of the foil. Do not separate the “BLUE COLOR CALIBRATION SHEET”.
Step 2: Load the stack of paper with the “BAR CODE” side face down
A and glossy side face up
B .
PRESS THE POWER BUTTON TO TURN ON THE CAMERA
The LED light will turn white when ready and a chime will sound.
PUSH THE VIEW FINDER DOWN TO TURN THE CAMERA OFF
The LED light will turn white when ready and a chime will sound.
Comments
0 comments
Please sign in to leave a comment.